Groove Coaster Controller

thingiverse

Human: # Groove Coaster Controller GrooveCoaster Controller replica with dimensions from real cabinet (reposted from https://github.com/vikbez/groovecoastercontroller) Box is 20 x 10 x 56.5 cm (part linking the ls32 and joy_stick is missing in this picture) # needed - a teensy 3.2 or 3.1 - a 3D printer - a laser cutting machine - 5mm plywood - 2 x seimitsu LS32-SE joysticks - 2 x 60mm buttons - 2 screws for locking the top of the sticks - 2 x large 6mm washers - 2 x anti vibration 6mm nuts - 8 x computer fan screws - wood glue # things to 3d print - 2 x joy_stick.stl - 2 x joy_base.stl - 2 x joy_tube.stl # things to laser cut - 2 x box_side.dxf - 2 x box_insert.dxf (goes on box_middle, helps for rigidity) - 1 x box_front.dxf - 1 x box_front.dxf (with a cut for your usb panel mount adapter) - 1 x box_top.dxf - 1 x box_middle.dxf - 1 x box_bottom.dxf # assembly ### warning: look at the picture ! be careful on which way goes up during the box assembly ! box_middle should be closer to top, not to bottom - Assemble the printed joy_tube onto the ls32 sticks using the washer and nut. - Screw the ls32s into place on the box_middle (joysticks underneath the board) with fan screws. - Glue the joy_bases to the box_top with wood glue. - Assemble the sides, front, and top panel using glue. - Install the 60mm buttons onto the joy_sticks, and solder wires to them. - Assemble the joy_sticks onto the joy_tube. - Solder wires to the ls32s. - Connect everything to the teensy. - Assemble the bottom panel and rear panel once you've confirmed that everything works. # soldering - Solder a GND wire to all LEDs and buttons. - Solder pins A5, A6, A7, A8, 3, 4, 5, 6 to left and right joysticks. - Solder pins A4 and 7 to left and right buttons. - Solder pins A3 and 8 to left and right LEDs.