Grimm Forest Upgrade Pack

thingiverse

I'm a huge fan of Grimm Forest, but combining cardboard tokens with amazing figurines just doesn't do it for me, so I created my own resource tokens. Each token has its numeric value carefully engraved onto it. To print these, you'll need to create the following: 20 Straw Tokens 15 Brick Tokens 15 Wood Tokens Note: The manual is incorrect about the number of resources listed; this is the correct amount. These tokens will fit perfectly in the insert if you're organized and use the picture as a guide for how I did it. I also sleeve all my cards, but the Grimm Forest insert just won't accommodate them, so I came up with my own card holder. With only 12mm to work with for the card storage, I had to get creative. When you print it, notice that there's a 0.25mm lip hanging over the cards - this is small enough not to need any support during printing. The lip will hold about 20 cards when held upside down; simply slide the cards in a few at a time until each slot is full. I used Mayday Games Premium green sleeves, which are shown in the picture and measured exactly for a perfect fit. I can't promise that other sleeves will work with this setup. This pack should enhance your enjoyment of Grimm Forest! **For the wood resource token, I used "A Simple Log" since it was perfect for my needs - I shrunk it down so 15 would fit perfectly in the token holder and 'welded' four together to produce the four-stack. You can find this design on Thingiverse: https://www.thingiverse.com/thing:1453301