Grimdark Future walls

thingiverse

I don't like the wall system from the most popular wargaming company, so I created my own that goes together easier using magnets. These should all print without supports on an FDM printer with the flat surfaces against the build plate. You'll need 5mm x 1mm round magnets for assembly. Be very careful to make sure you keep the orientation of the magnets consistent! To assemble the hatch wall you'll need a piece of rod (like a paper clip) and if your FDM print is tuned as poorly as my Ender 3, you'll also need a pin vise. My steps for assembling the hatch walls were: * Print off 4 matching door & wall files along with the hinge (the hinge works for all 3 door combos) * Remove any elephant's foot with sand paper, files and/or a hobby knife * Drill out all the hinge parts with a pin vise. * Glue the two parts of the door together, being careful to center the smaller half as best as you can. * Attach the hinge parts together with a paper clip * Put a drop of super glue on the very top and bottom of the hinge to stop the paper clip from falling out * Glue the two parts of the wall together * Put super glue on the bottom of the hinge where it attaches to the wall * Put the door in the wall and hold (or clamp) the hinge to the wall while the super glue dries with the door in the closed position. **UPDATES** **12 March 2023:** Added one additional walls remixed from https://www.thingiverse.com/thing:4679940 (was two, but one didn't print well. **13 March 2023:** Added an additional wall remixed from https://www.thingiverse.com/thing:5142192 **14 March 2023:** Added a new door with a heftier hinge. It still requires a paper clip or similar rod of approximately 1mm. The new door files all say "door v2" in the name. I've been pretty happy with printing most of these at .2mm height on FDM, but some of the details on the "Right door v2..." files really benefit from .16mm layer height. **22 March 2023:** Removed the old door files, uploaded 3 different door & wall combos that all use the same hinge. Unfortunately the 7th wall half I made turned out to be using a file that doesn't allow remixes, so I will only be sharing 6 wall side designs.