Gridfinity - Engineer Pliers Bins

prusaprinters

Assortment of Gridfinity bins to store and organize Engineer pliers.I created the bins to be used with this model: https://www.printables.com/model/543553-gridfinity-storage-box-by-pred-now-parametric The bins are all 3 units high.  Their width varies depending on the number of pliers stored.Gridfinity binsDimensionNumber of pliers stored5x4x3u44x4x3u33x4x3u22x4x3u1 I tested the bins with the pliers shown below: Other pliers like the one supplied with the Prusa MK3S/+ kit are also fitting. Compatible pliersNP-05Micro nippersNS-04Micro nippersNS-06Micro nippersNZ-03Chip cutterPS-01Miniature long nose pliersPS-03Miniature needle nose pliersPS-04Miniature flat nose pliersPZ-57Screw removal pliers (Nejisaurus) Print SettingsMaterialI printed and tested with PETG for impact resistance.Other materials like PLA should be just fine too but I haven't tested the model with it.SupportsI recommend using paint-on supports at each of the unit intersections (the blue “dots”) and using organic supports (I don't know how I could live without organic supports).Nozzle and Layer HeightNozzle:I printed and tested with a 0.4n, a 0.6n should work just fine and will print a bit faster too. Layer Height:I recommend 0.3mm layer height.0.2mm layer height worked fine too during testing but it takes significantly longer (12+ hours), and I had some minor adhesion issues in two of the corners after 10 hours.0.3mm printed much faster (~8 hours) and looked just as fine if not better.Top fill patternHilbert curves everywhere!  I am a sucker for Hilbert curves, I like the finish it gives on top surfaces instead of the linear finish.  This is totally optional…