Gridfinity Bin with Printable Label by Pred (parametric) without magnets

prusaprinters

Changes compared to the original modelRemoved the magnets on the bottom of the binsMade it possible to disable the scoop by setting HasScoop to 0 in the parametersFixed a bug with the division “wall” not being long enough when the Y length is more than 1Fixed a bug where there was a little thing “poking” through the label area when there were more than 1 divisionsDescriptionThis is a bin. A #gridfinity bin. The only special thing is that it has a label holder for a printable label.Print as you would print any Gridfinity bins. I use 0.4mm nozzle, 0.3 DRAFT profile and 10% infill.The label is 0.8mm high (0.4mm base, 0.4mm letter and border on top), print it at most at 0.2mm layer height with a 0.4 or 0.25mm nozzle. Once printed, let the whole thing cool down to prevent it deforming.The label has 2 small tabs on the side and the bin has 2 matching slots, insert the label by carefully bending it a bit. The two holes on the sides are there to help to remove the label using a pin or a tip of a blade.STEP files for the labels are attached.There is a parametric Fusion360 (F3D) file attached, you can adjust of course the width, the length and the height. On top of these, there are options for the wall thickness, bottom thickness, scoop curve radius, label width (that translates to the label holders total width) the number of divisions within the bin.I uploaded some sizes I use frequently, the list might get updated as I need new ones. Use the parametric file to configure your own.For smaller boxes 0.9mm wall thickness (2 walls) might be enough, for bigger ones 1.5mm is recommended (3 walls). This of course depends on the layer adhesion of the material and printer.File namingGridfinityBin_XxYxZ_DA_LB_SCX is the number of Gridfinity units (42mm) on the X axis (front)Y is the number of Gridfinity units (42mm) on the Y axis (sides)Y is the number of Gridfinity units (7mm) on the Z axis (height) A is the number of divisions inside the binB is the width of the label in millimetersC is the radius of the scoop curve in millimeters (0 when there is no scoop)Print a box to store them: https://www.printables.com/model/543553-gridfinity-storage-box-by-pred-now-parametricMore info about the Gridfinity system: https://gridfinity.xyz/