Gri

thingiverse

Instructions Using the following options: Bar style is chosen only, Lug style is plate, Font narrow widens not at all, Bar length trims to none, Bar width set at five, Text color chosen as DarkRed, Lug width set at five, Writing direction from left to right, Ruler unit selected at 10, Line spacing picked up by one and four tenths, The first extruder used for bearing, Outer margin width trimmed down to one, Glyphs coalesce strategy set to both bar and glyphs, Font outline style chosen as rounded, The only monochrome used in a third position, Outline thickness measured at three point zero, Text extruded using the second one, Font outline width reduced to half of five, Bar thickness comes out at two and four tenths, Border width not there, Font weight is zero, A particular font chosen with no style applied, The name of the font selected as Chewy, Border color picked up as Black, The second extruder used for border, Border thickness measured in point six, Inner margin width trimmed to one, Glyph coalesce threshold set at 25 points, Bar shift stays unchanged, Character spacing is only by one, Outline color chosen as Gray, A specific line number does not exist, Line 4 number still blank. Line 3 also still left out, Another number line blank. The fifth and last blank. Lug text distance chosen in inches at two, Bar color chosen by Khaki, Extruder first one again used, Text thickness measured in points of four point two, Minimal color layer is set in the fraction of zero point six