Greg3d BMG + V6 for Geeetech A10

thingiverse

Current Work in Progress: Modified for Geeetech A10 Expect tolerance differences and possible fitment issues as I figure it out. Shoutout to Greg3d for creating an impressive extruder/hotend setup! I adapted this design to the A10 but made some minor changes: One-piece back-mounted through hole to the bearings M3 nuts used to secure the front half on Generous cutouts for fan and wire management With these changes, I kept the original fan shroud geometry and profiles for the extruder. Offset from the original Greg3d extruder by 5mm on the y-axis towards you. Use stock bolts without washers on the two upper carriage mounts; bottom hole will need a washer to fit properly. This is done to facilitate installation while keeping the duct geometry intact. PLS note, this is NOT finished and may have fitment issues. Print at your own risk. Step and SLDPRT files to be posted once fitment is verified. Update for 2/11/2020: The part fits well on the bracket so I'll release the SLDPRT and STEP files later. Update for 2/19/2020: Step files uploaded. Project is now considered done and archived. No additional work or features planned but comment of any discrepancies found.