Greg's Wade's Accessible Extruder (based on 5th gen modded with quick release washer and wire management)

thingiverse

This is my slightly modified version of Greg's Wade's Accessible Extruder, 5th generation. The main reasons for this redesign are a French cleat washer with a finger grip that makes it easier to open the guide rail door and a post protruding from the front with a slot for securing all wiring on your X carriage using a zip tie. The tilting guide rail door screws have been resized to M3 screws and square nuts. The saddle and hotend holes are designed to accommodate an E3D V6. Test STL files include test fittings of all hardware in the same orientation as they will print. I also recreated the model from the STL file using Fusion 360 (here's the [model](https://a360.co/2BZ7RIi). There are user parameters that allow you to change some hardware hole sizes, including hotend holes and saddle, and a few other settings. You can also adjust the offset of the outside hobbed bolt bearing by specifying the distance from the inside of the bolt to where the hobbed groove starts (assuming a 3mm wide groove) and your washer's thickness.