Grasshopper Quadcopter v1

thingiverse

All original design is based loosely on a grasshopper and specifically for my set of components. This is a work in progress. 4/5/16 - The battery box and battery box top were updated for improved fitment, along with the power plug adjusted to fit an XT90 female plug in the battery box. My list of equipment that fits into the design: NAZA LITE Flight Controller is located at the Top Shell. Andoer Folding GPS Antenna can be found at the Top Shell. LED control board (36x36mm) is situated at the Top Shell. Andoer Power Distribution Board is housed in the Boom Body. RioRand Camera Gimbal is positioned at the Bottom Shell, with a Gopro 4 Session attached. DJI E310 Motor Kit (ESCs) can be seen at the Battery Box. Multistar 4S 8000mAh battery resides within the Battery Box. Futaba R2008SB receiver is located at the BatteryBoxTop. DJI E310 Motors are mounted on EngineMounts, as expected. Large LED Lights, both red and green, are installed in ledmounts. Additional components required include two carbon fiber tubes with 12mm diameter and 300mm length for back motors, two carbon fiber tubes with 12mm diameter and 135mm length for front motors, two carbon fiber tubes with 10mm diameter and 200mm length for front legs, and one carbon fiber tube with 10mm diameter and an estimated 80mm length for the back leg.