Graphics Tablet Wall Mount Holder

thingiverse

Wall mounted holder for a graphics tablet and pen case. I specifically designed this for an XP Pen Deco 03 but should fit any graphics tablet 12mm or less in thickness. The pen holder part is 35mm in diameter but has a clamp to keep smaller cases snugly in position. Assembly The two clamps used to hold the tablet and pen case firmly in place should be attached using M3 nuts and bolts. The tolerances are a bit tight when printing, so the clamps will probably need reducing in width and the holes may need drilling out with a 3mm drill bit. The cavities for the nuts will likely be quite tight as well. I suggest screwing a nut onto the end of the bolt first, then holding it with pliers and heating the nut with a lighter or blowtorch until it's warm, before placing the nut in the cavity. This way, the plastic will stick to the metal, providing a nice tight fit. Fitting I left the back wall of the model blank so you can decide how to mount it and drill the appropriate hole. Just do whatever you normally do when mounting a shelf or something. In the UK most houses have brick walls or breeze blocks inside, so I used a hammer drill and some wall plugs, but you could nail it on or do whatever works best for dry walls in your area.