Grand Power Stribog Magazine Adapter - XD

thingiverse

Magazine Adapter for Grand Power Stribog PCC Enables Use of Springfield XD Mags. Each Springfield XD mag requires an adapter to function properly with the Grand Power Stribog PCC. The adapter is glued onto each magazine separately. Since XD mags are based on Beretta M9 mags, other models may also fit. However, the mag's vertical orientation causes issues with feeding rounds. The last round often gets hung up due to its angled position. This magazine adapter works as follows: * Locks into place securely * Feeds most rounds, except for the last one The adapter has some limitations: * Fails to feed the last round in my experience * Does Not Activate the LRBHO (Last Round Bolt Hold Open) Minor adjustments are necessary to ensure proper function. 1. Print and attach the adapter to the magwell. 2. Load an empty mag into the adapter/magwell with the bolt forward. 3. Push the mag up until it contacts the bottom of the bolt. 4. Work the bolt back and forth several times to confirm free movement. 5. Open the receiver halves by pushing out the rear pushpin, load snap-caps or inert rounds, close the receiver, and then push the pin back in. 6. Confirm proper function by checking for smooth operation. 7. Open the receiver halves again by pushing out the rear pushpin, apply glue to the adapter from above, and attach it securely to the magazine. 8. After the glue has cured, eject the mag/adapter assembly.