Graflex open viewfinder rear part

thingiverse

I used to own a Graflex press camera that was missing a crucial part of its open viewfinder, and I couldn't find a replacement anywhere. Luckily, I had another one with the exact same configuration intact, which I could use as a reference to take precise measurements for making a new part. After careful planning, I created a perfect replica that works flawlessly. To print this part, simply place it flat side down on your printer and set the resolution to 0.1mm at a slow speed. You won't need any support structures because they're already built into the design - just cut them open with a sharp knife before using the part. Please note that the preview picture might make the gaps in the lower section appear closed due to the support structures. However, you'll need to slit open the inner side surfaces next to the click openings before inserting the lower section of the rear viewfinder part. The parallax correction clicks on the viewfinder are positioned as follows, from top to bottom: - Infinity - 15 feet - 8 feet - 6 feet