Graflex Clip

thingiverse

**Update 3/18/2018**: I've uploaded all four combinations of the clamp body (with and without inner tabs, and with or without the GRAFLEX text). Additionally, I updated the connector between the lever and the threaded piece. The transistor and washer are now designed with a clip-in attachment through the side holes; I strongly recommend gluing in place for a permanent connection. Two plugs have been uploaded to attach other pieces through the connector (right or left twist) via the inner tabs. Please note that these parts haven't been tested, so I can't guarantee their functionality or the strength of the tabs. **Update 3/14/2018**: The final clamp body file is now updated with four accurate grooves instead of the initial three in my first design. Photos of a print are also included to show the final file. Note that due to bent-in tabs, you'll need to use supports. I got tired of lightsaber designs cutting corners on the Graflex clip. Either it's a single rigid piece or uses a hard-to-print pin. Most designs lack the original text and lines found on the part. I decided to make a fully working Graflex clip in separate pieces for easier sanding, filling, and covering with standard aluminum duct tape. One design change was reducing the lines from four to three and making the text more bold to improve resolution on most printers and under the tape. There are two versions of the main clip: - The stock Graflex clip with text and bent tabs (requires support to print) - A cleaned-up Graflex Clamp with no text and no tabs (does not require support to print) This is still a work in progress, but it's getting close. If you download and print, please share any thoughts on changes I should make.