Graco Pack and Play Support Pieces

thingiverse

I inherited a Graco Pack and Play PD348808B from 2015 and the changing pad that sits atop the crib didn't have any of the support pieces to secure it to the top. These are the two pieces I needed to secure the changing part. It sits right next to the bassinet. The support piece should print without special adjustment. The rod fit snugly scaled to 16.5mm but I needed it to be longer so scale the Z out to however long your version needs to be. I ended up printing at 120mm on the Z. At 50% infill I was able to run a screw into the support rod and have it feel pretty solid. Updated - I added them as STL's and also made the rod be 120 if you want the same as I used. Good luck and this is my only post so please leave me a note if you actually used this thing