GPU Support ice and Case Decoration

thingiverse

Covid boredom drove me to design this. :p And it's open to change, so I didn't hide the extra LEDs sticking out. I started by needing a graphics card support for sag. This is 80mm tall when put together, so add or subtract height as you need for yours. There are large and small designs for both the top part of the case and the GPU support. You will need to print the GPU_TOP twice for the large one. A tunnel is built into the large support so you can run an LED strip for lights. It's hard to tell from the video, but it makes it look a lot cooler, in my opinion. I also added the Gears COG for some extra flair. I only used Cura supports on the large GPU support to keep the light tunnel from collapsing. Zero infill % on the ceiling piece, 10% on everything else. Two small screws hold the ceiling pieces on through the fan mount area on the case. https://youtu.be/L5Z-F4tf5PY