GPU-holder

thingiverse

Hello,\r\nAfter discovering that the EVGA 1080Ti-FTW3 card wouldn't fit in the Louqe Ghost case, I began experimenting with Inventor to find a solution for utilizing my expensive GPU in the new enclosure.\r\n\r\nThis custom bracket/holder will lower the GPU/riser-cable by 10mm from its original position, allowing the use of standard cables with my Corsair SF600v2 PSU. However, more rigid or harder cables could still pose a problem, but with low-profile connectors, this shouldn't be an issue.\r\n\r\nThis modification also means that the LED-stripe no longer needs to be removed from the top of the card.\r\n\r\nNote: When lowering the riser cable, you'll need to straighten it and re-bend it at a new position!\r\n\r\nVerify this: In another slicer software, the scaling seemed off. The total height of the piece should be 11.7mm! (Edit: only for v1)\r\n\r\nVersion 2: Additional material was added to the top right side based on a request. I haven't printed or tested it yet, but there might be issues with fitting it in. Please comment if it does/doesn't fit.\r\n\r\nAlso, this version seems fine in terms of scaling.\r\n\r\nVersion 3 (2019-07-10): Larger holes were added for a better fit in the ghost case, while screw holes remain the same size. A modified structure was also added to the right holder to accommodate the GPU/riser fastener more securely. I consider this version final.