GPIO exposed Sleeve Case for Raspberry Pi B+

thingiverse

I have numerous coils of wire that were a bit disorganized. I was either taping the loose wire end or inserting it into the coil. I thought a plastic clip would be a better way to keep it in place - and here it is. The coils I am using are usually available from Fry's, Micro Center. They are typically 50mm in diameter when fully loaded and shrink to about 30mm empty. I made two sizes for each of two reel heights, one for a coil that was mostly full and another for a coil that was nearly empty. Unfortunately, I do not have an almost empty coil, so I wasn't able to test the 30mm size - but I am unsure why this wouldn't work. Print Settings Printer: XYZ Da Vinci 1.0 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: .3 Infill: 10% Notes: Nothing unusual about the print. I used a glue stick to attach the print to the bed. No rafts or support needed.