GoUP!.gcode

thingiverse

Just some simple G-code to move the head up to access the bed for double Z printers without specific commands - like those used with Marlin. goUP!.g>>>Move up 100mm goUP!50.g>>>Move up 50mm goUP!200.g>>>Z home and move up 200mm goUP!50HeatUP>>>Move up 50 and heat up to 200°C Very easy to code for beginners using control+F and searching commands on this website: https://reprap.org/wiki/G-code Of course, you can modify it using notepad or other text editors to adapt it to your needs! For reducing setup time, no homing before G28 Z is required. Disclaimer: I am not responsible for any damage caused by this G-code. Especially if you don't home the printer first, keep in mind that the printer can go too far and block the Z motor!