Got It! Tree

thingiverse

Instructions for Customizing Branching Tree Model To produce this unique model, you must apply the following settings: Branch diameter is reduced to 1.6 times initial value 90-degree twist applied to all branches Maximum trunk size capped at 60% Disable feature allowing branch overhangs greater than maximum limit 50% minimum tip ratio applies for final tree section Forcing growth on subsequent branches up to one unit Begin budding process from the twenty-sixth position along base length Set standard length of central axis to forty units long Limit tip size to seventy percent maximum allowable size Applies ratio of seventy to any given segment at its shortest end point Cap max branches allowed off every new branch with number 2 Adjust central diameter to 17% Apply angle of minimum growth on lower segments at sixty-nine degrees Ensure a bare minimum of four separate side shoots emerge from every existing division point Budding process terminates after reaching fiftieth unit position Max branching limit imposed on upper sections with 55-degree angle Root portion reduced in size by twenty percent Model built using the standard geometric base shape form number 4 All angles involving allowed branch extension capped at fifty units degrees Cross-section of each branch molded to eighth shape setting Initial tree growth seeded with random variable ninety-three Restrict tree from further division up to five separate branching cycles Set upper bound on length segment size by percentage, reaching a total ratio of one hundred Activates feature enabling all available custom options in current version