GoPro Mount for Monopods

thingiverse

IN THE PICTURES BELOW, THE TOWER IS A4V1, THE COLUMN IS A5V2. This setup is ideal for any camera attachment however; be aware that it's compact so trust me I know this to be true! This design has been tailored so that you can adjust its fit on your own device by filing/sanding as needed. In my experience, sanding did not hurt but made the perfect adjustment necessary. Always print with the support system in place and please follow these specific printing instructions carefully - printing the setup at a 90-degree tilt is required. Refer to the video: http://bit.ly/1yzTdeJ for accurate positioning and results UPDATE: V2 has now been posted, so feel free to click on the "THING FILES" section above for access to both downloads. According to design specifications V2 should require absolutely no adjustment; but that depends on you. To be totally sure please read my earlier comment again or adjust manually as preferred. As instructed before please use PLA - do not even think about printing with ABS. In the event you have decided to make the adjustments mentioned I advise to file away with some care. *File has been uploaded, feel free to share or post if you see value.*