GoPro Mount arris 250

thingiverse

Human: Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=1068400 Instructions Using the following settings: - No lip is used. - Camera depth is set at twenty-one units. - Front calipers measure thirty-five units in length. - The front edge of this design sits exactly zero units away from its front-most point. - Rear calipers are thirty-five units long. - Screw head size has been established at six units. - Base thickness has been designated at three units. - Edge margin measures precisely three units across all dimensions. - Front-to-rear distance in this setup equals twenty-five units in length. - Velcro is made to be exactly three units thick. - Velcro width reaches an impressive eighteen units from left to right edge, while its vertical depth stretches equally thirty units along back surface direction so as reach highest peak which amounts up thirty units! Hole diameter of this part measures exactly three point two millimeters. Lastly but most critically: The designed angle we are aiming here comes down precisely twenty degrees around central fulcrum pivot at top end face giving clear vision underneath due reduced shadows everywhere you want looking forward; Back surface vertical depth heighten by another ten on bottom, totaling fifty over entire span