GoPro Hero9 Media Mod case tidy

thingiverse

This is a remix of csaktom's case sortiner so i could include a space to keep the media mod. I decided to go with a design that uses the entire bottom section and is low profile enough to still allow storage of things in the top netted area (bonus for me, the clip does stay nicely there when i close my case). There is some flexability in what you can store in it. For example you can store the media mod and camera seperately thanks to a dedicated spot for both the camera and media mod seperately. This allows you to carry two cameras if you wish, one in the media mod and the other in the dedicated camera space. I have also shown an example of using the dedicated camera spot as extra storage when using one camera inside the media mod. There is spots for three batteries, the tri-pod selfie stick and an sd-card holder. I printed it out on a Flash Forge Adventurer 3 with the following settings: PLA No Supports No Raft Standard Resolution Layer height - 0.18 Perimeter Shells - 2 Top/Bottom Solid layers - 4 15% hexagon infill It is bigger than the platform for my printer, so i sliced it in half using the flashforge printing program and printer each half seperately.