GoPro handlebar flat mount

thingiverse

This 31.8 mm GoPro handlebar flat mount is printed in three parts: The clamp top, clamp bottom and flat mount itself. The flat mount is screwed onto the top part with four M2.5 x 12mm countersunk wood screws after inserting the two M4 lock-nuts into the pockets in the clamp top. The clamp bottom is then affixed with two M4 x 25mm hex bolts. The mounts are laid flat on the build surface and can is printed without supports. This way the strength of the clamp is not dependent on layer adhesion. BOM: 4 x M2.5 x 12 mm countersunk wood screws 2 x M4 lock nuts 2 x M4 x 25 mm hex bolts