GoPro handle

prusaprinters

<p>This is 2 parts to make printing easier.</p> <p>I make a lot of GoPro mounts but I was never 100% happy with them, too tight, too loose, holes too small.... So I completely redesigned this one and I may be updating my other models with this connector.</p> <p>Also, I found something important for printing thin walled items like the GoPro mounts (fingers), it's important to only have 2 perimeters and then 100% infill. I use to print with 4 perimeters but it turns out that is way too weak because of layer adhesion. See this thread for the full story <a href="http://forums.reprap.org/read.php?262,357700">http://forums.reprap.org/read.php?262,357700</a></p> <h3> Instructions</h3> <p>Print the mount separately solid with 2 perimeters.</p> <p>The handle can be printed with 3-4 perimeters and 10-20% infill.</p> <p>If you print using ABS simply glue together with a little Acetone. For PLA use glue.</p> <p>The nut should fit snug but I suggest you glue it in place as well.</p> Category: Camera