GoPro Handle

thingiverse

Here is the spun text in American English. Mount this two-part system by printing each piece separately and then assembling them using adhesive. The pieces will require a small amount of fine-tuning through sanding to ensure they fit perfectly, thanks to the 0.5mm tolerances built into the body part. Assembly Instructions: Print with 100% infill for best results. While lower print quality settings can be used to speed up production, medium or higher settings will produce better outcomes. Use super glue or J-B Weld for assembly and make sure to sand both bonding surfaces for optimal adhesion. Additionally, the top inch of PVC will require a bit of light sanding where it fits over the outer casing, but this process creates a tight seal.