GoPro Bracer Mount 360º - Soporte muñequera

thingiverse

Human Support for Doll, Arm or Leg: Rotate 360° and stay fixed automatically every 10° using a hinge mechanism. Removes GoPro camera with universal mount without adjusting the regulating screw. Achieves virtually any angle by using 360° rotation and turning on the screw. Mounts and removes easily on the body with or without clothing using a velcro strap. Print Settings Printer: Replikat M5 Rafts: No Supports: Yes Resolution: 0.15 Infill: 100% Notes: Printed in PLA The GoPro Mount requires support due to long overhangs. The Aro Snap piece also needs a lightweight support for the cavities housing other pieces. Most other parts can be printed without support. Cura Settings: Quality: LH 0.15 ST 0.8 ER Yes Fill: BTT 0.8 FD 100% Speed and Temperature: PS(mm/s) 50 PT 190 BT 70 Support: ST Everywhere PAT None. Filament: D 1.75 F 99% Pico 0.4 / Infill 100 Post-Printing Clean the parts removing any excess filament from printing. Apply white soap to areas with friction for smooth operation. Pieces fit together seamlessly; little or no assembly is required. Test the pieces until they work correctly and then glue Cremallera and Aro Snap pieces together for secure fixation. The strap is a 25mm wide backpack clip with velcro on both ends, adjustable in length up to 40cm depending on intended use. How I Designed This Modification went through several stages. Initially, the design aimed for minimum pieces while integrating everything into one part. However, this required support that was difficult to remove afterwards. The mechanism underwent adjustments and fine-tuning until it reached necessary stiffness. Some curves that accompany arm or leg movement were tried but they compromised quality as they needed support.