GoPro Bike/Bar Mount

thingiverse

GoPro Bike/Bar Mount Print Settings Printer: FF Creator Pro Rafts: Yes Supports: Yes Resolution: 0.20 Infill: 70% Notes: Material - ABS Post-Printing Removing support material was effortless, but rafts were a bit challenging Design Changes Adjusted variables to accommodate nuts and bolts I had on hand // Screw head diameter gopro_bar_screw_head_d = 7; // Nut diameter gopro_bar_screw_nut_d = 7; // Locking nut diameter gopro_nut_d = 8 Custom Section What I Learned Polishing with a Dremel tool is not recommended - it causes plastic to melt quickly at high speeds, resulting in loss of shininess A brief nail polish bath of less than one minute smoothens out the surface but creates an unsightly white crust and discoloration Using a lighter to restore appearance only makes things worse Dremeling again removes most of the crust, but it's still not ideal The end result is acceptable for its intended purpose as a bike mount, although it may appear subpar on a high-end Amsterdam bike.