Google Home Mini Recessed Mount (Removable)

thingiverse

This is actually an addon to the fantastic recessed mount found here: https://www.thingiverse.com/thing:2731084. The settings on the original don't allow upload of remixes so unfortunately could not be linked back here. The problem with the original mount was if you wanted to install it in the ceiling, you needed to be able to access it from behind to be able to cable tie or glue the mount in to place permanently making removal and/or maintenance extremely difficult. This component allows for the above mount to slot in and out like a downlight by turning the inner component and allowing it to slide away from the outer sleeve. Outer sleeve can be mounted in the ceiling or wall without needing to get behind it by way of some lock down clamps that are installable via the cutout. The "inner" mount is the same as the original with 2x wings added to allow it to lock into the outer mount. Cut out diameter is 110mm, and you will need; 3x M3 20-25mm Bolts (dome head to they hide easily under the lip) 3x M3 Hex Nuts to slot into the locking pieces Installation instructions: Simply cut the 110mm diameter hole where the Google Home Mini will be mounted, slot in the "Outer" component, push bolt up through the three mounting holes, place locking clamps over the bolt and tighten. Check the orientation of the Google Mini so that the power cable aligns with on of the large cutouts in the "outer" and push the Mini firmly into the "inner" component. Place the power cable through the large cutout in the outer identified above, and plug into the Mini. Align the wings of the inner piece with the slots on the outer piece, slide up and turn clockwise to lock into place. The M3 bolts should be concealed within the recess under the lip. To remove, turn the inner/mini anti-clockwise and gently pull back down.