Gonk GNK Power Droid Sectioned

cults3d

I had some trouble with the original model with supports so I decided to try my hand at breaking the model in sections. The top part has two holes under the brim for connecting to the middle half. The middle half has two holes for connecting to the top and two holes for the feet to insert. The feet are printed with small pegs on top to slide into the middle part. The pegs on the feet and the peg inserts for connecting the body together are slightly smaller then the holes, you may need to do some light sanding or finishing to get them to slide properly. I supplied two different peg inserts, one is 4.6mm x 9mm the other is 4.6mm by 8.5mm, The holes for these pegs are 4.8mm x 9.8mm (was original intended to be 5x10, but had a small mix up) I am considering changing the feet so that it has holes as well allowing for a customized peg insert there as well. Hope it prints well for everyone.