Golf Cart Cooler Mount

prusaprinters

<p>This is a custom cooler mount for a &nbsp;2021 Ez Go RXV Golf Cart that has the custom 4-seat add-on. When adding the back seat, the supplied Ez Go Cooler no longer fits. This design clamps on a side bar. It mounts with four ¼-20 x 2.25" long bolts. A couple of notes about the design:</p><ol><li>I did not print the hex head pockets in the plate because I wanted to use washers under the hex heads for additional strength.</li><li>I used ¼-20 Nyloc Nuts to ensure everything stayed tight as the cart bounces around.</li><li>I added some thin pockets on the inside of the plate for strength. They don't show in the final prints because I made them pockets 0.03" above the bottom surface and 0.03" below the top surface. You can see them when you slice the plate.</li><li>Print settings:<ol><li>PETG (for outdoor use)</li><li>4 perimeters (for strength)</li><li>30% Gyroid Infill</li><li>Supports on (for the bolt pockets).</li></ol></li><li>I also printed it with Variable Heights enabled for the slight horizontal taper in the Plate. I set it to 0.1mm for the taper area and 0.2mm for the balance of the part.</li></ol>