Golden Ratio Pyramid Pipe Connectors (customizable by fusion360)

thingiverse

This is a pipe connector for forming a golden ratio pyramid. You can make pyramid of various sizes using pipes of various sizes diameter. Customization is done by changing the parameters of fusion360 file (.f3d). [Features] -Customizable for various pipes and screws -Fixed firmly -Hard to break even if squeezed strongly with a wrench -Easy to remove from the pipe [Design point] -Designed so that when the bolt is tightened, the bolt is parallel to the pipe. This enabled stable tightening. [Customizable parameters] -pipe inner diameter (min:8mm at M3) -pipe outer diameter (I recommend 15mm or more) -screw size (M3, M4 ,M5, M6) Detailed screw dimensions are set automatically. Screws larger than M6 are also possible by manually setting the screw related parameters.(set "bolt_d", "bolt_hd", "nut_w", "nut_h". You need not change "ss") [Bolt/Nut type to use] type: Countersunk screw bolt and Nut M3 - M6 (If the screw heads do not hit each other, you can use screws of other head shape.) bolt length: approximately 1.3 times or more the outer diameter of the pipe [note] -When using a pipe with a small diameter(<15mm), the three holes that open at the top of the connector are combined into one large hole. I do not recommend applying this connector to small diameter pipes as they are not very good in appearance. [caution] important !! -The inners of the top and bottom connectors are not the same. The cut angle is different. 48.0 degrees in top, 45.1 degrees in bottom. Make sure to distinguish them properly. -If you get an error while changing the parameters, click the OK button in the parameter change window, and then click the undo button to return. This is because even if you try to change the parameters without undo to eliminate errors, the abnormal state may be maintained.