Golden Gun

myminifactory

This is a tribute to Scaramanga's gun from the iconic 1974 film "The Man With The Golden Gun." It's not movie accurate, but looks fantastic nonetheless. When disassembled, it breaks down into three harmless components: a pen, cigarette lighter and cigarette case. But put them together and... Once printed: 1. To assemble the cigarette case, press-fit the bottom of the case into the main body and secure the case lid to the body at the hinge using 3mm filament. 2. To assemble the trigger, insert a short piece of 3mm filament into the trigger and store it in your cigarette case. 2. To assemble the cigarette lighter, slide the breech into the main body of the lighter, with the threaded end facing outward. The breech has one end with a thread - this end needs to be positioned for assembly. 3. To assemble the pen, insert the pen clip into the pen top from the top and screw the cap (with male thread) into the pen top. Then screw the other cap (with female thread) into the other end of the pen and push the two ends together. They're provided in two pieces so you can fine-adjust the position of the pen clip to act as your sight. Once you've got the three pieces fully assembled, follow these steps to turn them into your golden gun: 1. Unscrew both caps from the pen. 2. Screw the pen into the lighter breech. 3. Slide the breech out. 4. Open the lid of the cigarette case, remove the trigger and slide the cigarette case catches into the slots on the lighter and breech. Push the breech back toward the lighter to secure the case. 5. Insert the trigger into the hole in the lid of the cigarette case. Now it's time to take down Mr. Bond. Please note that the breech may be a bit tight until it's had time to wear in. Slide it in and out a few times, and it will become easier to move, but don't force it initially as it can get stuck.