Gold Sluice V2 - Stackable

prusaprinters

<p>This is my second revision of my pocket gold sluice. Doesn't so much fit in your pocket anymore, but is MUCH simpler. Each section is a single piece, and nest together so you can stack it as high as you want (please, be reasonable).</p> <p>This is designed to allow almost any kind of matting you want to use, up to 5mm tall. Uses a bit stronger pumps than V1 as well. The top hopper has room for up to 4 hoses to be inserted, and used as a wash area. The pumps I'm using are quiet, small-ish, and only 12V, so you can take a small 12V battery with you and be good to go.</p> <p>I still need to design the mount that will allow this to sit on top of a 5 gallon bucket, so I'll add that when I get a chance. I'm still actively adding more parts to this, as well as fixing up minor issues with the models as I find them.</p> <p>Parts you will need:</p> <p>Very flexible 16mm ID hose. Latex hose or something similar will be your best bet.</p> <p>Pumps:<br/> <a href="https://www.ebay.com/itm/Car-DC-38mm-Electric-Submersible-Water-Oil-Diesel-Fuel-Pump-12V-Stainless-Steel/362898715153">https://www.ebay.com/itm/Car-DC-38mm-Electric-Submersible-Water-Oil-Diesel-Fuel-Pump-12V-Stainless-Steel/362898715153</a></p> <h3>Print instructions</h3><p>Print as they are. They are angled at 9 degrees, so although they look funny that way, it's meant to be like that.</p> <p>The hopper is the ONLY piece that MIGHT need supports inside the hose holes. If your printer is tuned well enough, you might not even need those supports.</p> <p>The other parts all print with NO supports!</p> <ul> <li>0.2mm layer height</li> <li>30% infill</li> </ul>