Godox TT600 Flash UV IR Filter Holder UVIF

thingiverse

Needed a device to hold a few filters in front of my modified Godox TT600. The filters slots will hold two 1mm thick and two 2mm thick 40x70mm filters. These are super affordable on Aliexpress. I'm using one 2mm thick UG11 UV pass filter and two 1mm BG39 IR block filters. I don't have accurate testing but it blocked all light output from the flash with the stock UV filters in place, and worked perfectly once modified. That's as good as it gets without spending hundreds or thousands of dollars. Parts were printed in ASA, there's clearance built in for everything, I used black gasket silicone to hold the front UV pass filter in place when there was a tiny light leak around the edges. The four parts are top, bottom, and two caps which snap into place just right. See the other pictures for the parts to remove from your flash to allow full UV, and a sample photo of a gecko on my door. Don't electrocute yourself opening the flash. You don't need to touch anything, just remove the screws, pop the case off, dump out the two clear filters, and put the top back on. This is a little bit directional, putting the flash into a tunnel, but it works. Could be made shorter if needed. EDIT Added a SHORT version that holds two 2mm filters and has them tucked much closer to the flash head. Just make the SHORT files. Thanks for making! Hope this helps someone get into UVIF and UV photography!