Go Pro Mount - Bell Moto 9/9S

thingiverse

Just a very quick remix thrown together from another mount for the Bell MX 9 I printed and tested out.It seems the Bell MX 9 has a slightly different shape in the chin area than the Bell Moto 9(9S).Basically just added a couple "blocks" at the end of the chin mount so that there is no play at all for the mount. Previously, the mount would move up and down; so when hitting whoops, rocks, or big bumps on my bike, it would cause the mount to move up and down and eventually my camera would be pointing down a lot(wouldn't really capture anything but my bike/legs/gas tank). So I made this.The fitment is very, very tight. So when you slide it onto your helmet, make sure the little "nib" piece at the top of the mount slides into the foam area of your helmet(vent for you mouth on the helmet). Unfortunately, the fitment is so tight that when removing the mount, it may snap/damage the mount itself. But, I'd rather have that than my Go Pro flying off mid ride.As for durability and reliability, I crashed decently hard last weekend. My go pro/helmet/mount smacked the ground pretty hard. Mount is still fine. I recommend printing in PLA+, PETG, or something stronger. Though mine is printed in PLA+ and has still yet to deform or crack, even after my crash.