Go Pro Hero 4 Waterproof Case Latch

thingiverse

This is the latch that secures the Go Pro Hero 4 Waterproof case tightly shut. Unfortunately, my latch cracked despite applying epoxy to seal it completely. For optimal results, this latch should be printed in an upright position. This ensures that stresses and forces are evenly distributed across the print, eliminating any potential weak points caused by layer lines. I successfully printed mine using PLA, which has held up remarkably well over time. However, looking back, I would recommend printing it with ABS instead of PLA. After a few sunny days, ABS can undergo elongation, which may cause it to weaken and compromise its structural integrity.