GMC Sierra 1500 center console magsafe charger for iPhone 13 Pro Max

thingiverse

I designed this one by request of my good friend Terry. We both have iphones and GMC Sierra 1500s. This will for sure fit a 2021 Sierra. Probably others that have the spot dug out in the center console lid... This one is designed for the iPhone 13 (14 should also work) pro max with a case on it. After printing, you remove the stock rubber insert from the center console lid. Remove the lid underside by pinching the lid latches together while pulling the cover off from that point. It is held in by little prongs and pulls off fairly easily. This gives you complete access to the inside of the lid. The Apple brand magsafe charger will pop right into the hole in the part if your printer settings are dialed in properly. The fit is EXACT. Make sure the business end of the charger face the plastic on the printed part. Then route the cable through the channel in the part and into the oval hole in the lid (this will make sense when you look at it). The cable can easily be router out through where the hinge arm goes through the cover and then plugged into the existing USB-C port inside the center console. That's it. Now your iphone will fit properly in the center console and will stay put with the little recess for the camera and the magnetic attraction from the magsafe charger. I will be making another for the Pro once I get his phone or someone else's to measure up and put the recess in the correct place. Printing advice wise, I printed on from PLA and it works fine. I did design this to be printed in TPU or flexible resin (why there are ribs on the top side) if you have a resin printer. I am going to try the latter next.