GM328 Transistor-tester battery holder

prusaprinters

<p>An enclosure/battery holder for the GM328 transistor tester. The box has a simple hinge that holds the battery in place under the tester, while leaving the board surface perfectly flush on the enclosure's rounded edge. This leaves all the features of the tester easily accessible, such as the sop contacts.</p> <p>The enclosure is a<em>tight</em> fit around the pcb (&lt;0.1mm gap). Push firmly the pcb until it snaps into place. M3 screws can be directly fastened on the support.</p> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.15mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>30%</p></div> <p><strong>Notes:</strong></p> <p>Be sure to inspect the infill for connection from the walls to the screw holes. At least two intersecting walls are required to build a sturdy mount. Increase infill if necessary.</p> </p></p> Category: Electronics