Glue Dust Tray for Zortrax M200

pinshape

Elmer's glue stick and the Zortrax perfboard team up with the raft to deliver excellent print adhesion for any material used. Unfortunately, my printer has a bad habit of collecting unsightly dried glue dust from scraping the bed between prints, so I created this slide-on tray to sweep away the dust and keep the printer clean. This tray fits easily onto the older v1 perfboard; users with v2 might need to enlarge the slots a bit. If printed in PLA like I did, it's probably a good idea to remove the tray when using the bed heater, but if you're printing with ABS, you should likely remove the bed altogether due to the required force. Since PLA prints don't need bed heat, they can be popped off easily without removing the bed. The design is editable on Tinkercad at https://tinkercad.com/things/evclLyuzWxCPrint SettingsRafts: YesSupports: YesResolution: 290 micronsInfill: "Light"Notes: Printed with Meltink's amazing PLA+PHA using a Z-Temp to set extrusion temperature to 215°C.