Gloomhaven Tracker

thingiverse

A custom-made tracker for hit points, experience, and gold is created for the Gloomhaven board game. Instead of relying on character mats that quickly wear out from tracking hit points and experience points, our group started experimenting with a 3D-printed pegboard concept. We still needed something in the middle of our play area to stack Discards and Lost cards on each side. After a few iterations, this design was landed on. The pegs are designed to be stackable, so 0-9 is represented by one peg, 10-19 with two pegs, and so on. Each session begins with the HP pegs showing the character's maximum, while the XP and GP start at zero. This pegboard was designed to be easily printed without supports and incorporates a simple color change without needing multiple extruders - just swap your filament between the last big flat layer and the first layer where numbers/letters begin to print (around Z=10mm, depending on your layer height settings.) If the pegs' fit is too loose or too snug, you might experiment with your settings. If bridging isn't perfect, printing without supports may leave a tiny bit less room in the holes of the pegs. On the other hand, using supports for the same holes may not be easy to remove and can leave behind some filament that can impede a perfect fit. The pegs are quick prints; try printing one both ways and decide for yourself.