Gloomhaven Player Dashboard STACKABLE + 26 HP/XP Tracker - English

thingiverse

Like with the original stackable, supports under the middle area are essential. I used custom supports in Cura and they worked flawlessly. In fact, I accidentally printed one without supports and while the bottom was a disaster, the top came out perfectly and the board remained completely functional. Once I cleaned up the tangled mess on the bottom, it's impossible to tell that it was printed without support. This printer prints smoothly on my Ender 3 with a .4 nozzle, 10% infill, and 60 speed at even .28 resolution. (Hatchbox Silver PLA.) Since I don't have a .6 nozzle like the version this is remixed from was designed for, I'm unsure how these slightly smaller numbers will translate on such a large nozzle. I've been experimenting with the HP/XP sliders to get them just right. You can use the ones from the previous version, but lower the Z axis down to 78.87% which is the exact reduction in size of the v-grooves inside the tracker slots now. Additionally, I found that printing the sliders with the semi-flat side facing downwards and support for the shelf part results in a cleaner slider than printing it tip-down with a brim. Your mileage may vary.