Gloomhaven Monster Stand Counter Standee

thingiverse

This is a remix of a life counter that I really liked, but really disliked the assembly procedure. No glue, or manual clocking required! As such, I resigned all the parts (besides the "ring"). This included a fixed post in the center of the base which acts as a locating feature for the springs and the standee top. I have printed about 10 of these and the top and base pieces should snap together in a fairly satisfying manner. You will the following for each assembly 1 base, 2 springs, 2 rings, 1 Top During print, the only part which requires support is the "Top" piece which should be printed in the standard vertical orientation. The ugly face produced by the supports will end up hidden after assembly. Print should be about 45min for all components, so a good "filler" print. When assembling, a few things to pay attention to: - Make sure the springs are installed in alignment - Make sure the top base arrow is pointing at a number (rather than a corner) during assembly. Should you mess the above up, you can take it apart with a flathead screwdriver, but risk breaking the central post which is fairly thin. With all of the above, there are a few things I have not gotten around to fixing: 1) There are a number of adjustments I want to make to the spring get better "clicks" when adjusting values. 2) I could redesign the post to be a pentagon and avoid the two assembly issues above, but I haven't found them obtrusive enough during assembly to warrant the time to fix.