Gloomhaven Legible Scenario Aid token

thingiverse

Inspired by UnrealSquare's Legible Senario Markers, https://www.thingiverse.com/thing:2803332 I made these double sided tokens the same dimension as the Gloomhaven's original tokens. Text on the top is 0.4mm thick, and bottom text is 0.6mm to account for sagging from overhang. To print in 2 colours, use this single STL. Gloomhaven_AidTokens.stl Print instructions: Layer height: 0.2mm 1. Print first 3 layers (colour 1) 2. Pause after layer 3 3. Change filament (colour 2) 4. Pause again after layer 9 5. Change filament (colour 1) 6. Finish the print To print in 3 colours, use these 3 STLs. Gloomhaven_AidTokensBottomRim.stl Gloomhaven_AidTokensCenter.stl Gloomhaven_AidTokensTopRim.stl Print instructions: Layer height 0.2 1. Print Gloomhaven_AidTokensTopRim.stl. (colour 1) You may need to slow down the print speed for this part. The wall thickness of this is 1.5mm and has only 1 layer thickness. 2. Leave the print on the print bed. 3. Print Gloomhaven_AidTokensCenter.stl with the settings below. Print the first 3 layers (colour 2), then pause Change filament (colour 3), and continue to layer 9. Pause after layer 9, change filament (colour 2) Continue the print 4. Leave the print on the print bed 5. Print Gloomhaven_AidTokensTopRim.stl (colour 1) with z-hop. Make sure this part is lifted 2mm off the print bed in your slicer.