Gloomhaven insert - single piece prints

thingiverse

Update 4/29/20 After a very long break, this is finally done. This update makes all of the 3.x files even out in height. The height was lowered slightly, leaving some room between the monster tray layer and the map board, making it easy to fit the rule book and scenario book inside (I also put all my stickers and envelopes in the rule book). Large map tiles are placed above the map board, while smaller ones remain in an accordion binder; I'm not sure if there's enough room to keep them in the box right now. Character boards and character/party sheets can fit under the character trays above the status/coin/damage trays. I realized that bosses can fit nicely in the monster tray, something I hadn't noticed before. The large dragon is placed in the map overlay tile tray under the 3 hex tiles though. Update 9/3/19 Tray 1.2 was updated so layer 2 trays no longer fall down into it; the inner walls were raised all the way up to accommodate hp/xp trackers that people put there, which may need to be placed in the top of the box instead. All layer 3 prints were cleaned up; these may be in a different order than before. A slight adjustment was made to tray 5. Update 8/24/19 Tray 2.1 was updated to fit larger figures after realizing they didn't fit in 2.2 and that I didn't have enough large spaces in the original design. A picture of tray 2.2 was uploaded. Remix of: https://www.thingiverse.com/thing:2735536 I had some issues getting multipart trays to fit together well, most likely due my 3D printer's configuration being slightly off. Imported into tinkercad and cut them up into smaller single trays. Trays 2.1, 2.2, and 5 should be printed twice to match the original design. Marking as In-Progress while I print these myself.