Glock Handgun Magnetic Holder

thingiverse

I whipped up a quick holder to keep my handgun tucked away beside my nightstand. I grabbed some neodymium bars, measuring 60mm by 10mm by 3mm, from Amazon. I doubled them up in each spot, so four of these babies got used in total. To attach it securely to the nightstand without scratching my handgun, I used #6 x 3/4in wood screws that sit flush against the surface. This setup holds my handgun snugly and worry-free, no risk of it falling off at all. I printed it with a layer height of 0.12mm, but you can crank that up if speed is your thing. I went with 20% infill for a good balance between weight and print time. Since the magnet cavities were facing upwards, I didn't need any supports during the printing process.