Glock G17 gen 3

cults3d

remember this is not airsoft, make no mistake 3.1 Print Settings For a light duty/workable frames: Material: eSun PLA+ Print Temp: 235 C Bed Temp: 60 C Bed Prep: Wipe clean, apply a thick layer of Elmer's glue stick. Kapton tape is recommended since this frame will really stick to the bed tight if you use the STL with the raft. Infill: 100%, Rectilinear Fill Enclosure: None Orientation: not super critical but using the STL with the raft will result in far less warp. Warp is the enemy of this project. Supports: full, hexagonal infill, sheathing on infill optional but recommended if your slicer supports it. Remember that PLA will not stand up to hot environments. While the gun itself won't hold enough heat to hurt the frame (I dumped 50 rounds as quick as I could load them without issue), having this frame sit in a hot car would damage it. For a heavy duty/durable frames: Material: Zytel or Glass filled Zytel Print Temp: 287 C Bed Temp: 100 C Bed Prep: Wipe clean, apply a thick layer of Elmer's glue stick. Kapton tape is recommended since this frame will really stick to the bed tight if you use the STL with the raft. Infill: 100%, Rectilinear Fill Enclosure: None needed, but it will not hurt if you use one. Orientation: not super critical but using the STL with the raft will result in far less warp. Warp is the enemy of this project. it was many hours of work!