Glock 26 Plus 3 Mag Extension to fit Polymer 80 PF940SC Glock 26 Frame

prusaprinters

<p>First off, thanks to, PrintedFirearm, for providing the "Glock magazine base extension", as it gave me a good starting point,</p> <p>and</p> <p>thanks to, joestrander, for providing the "G19 to G26 mag adapter."</p> <p>I modified the Glock magazine base extension file and combined and added the back part of the "G19 to G26 mag adapter" to it, providing a more stable and full grip for the palm area.</p> <p>This magazine extension fits well and was tested on a factory Glock 26 10 round magazine and was made for the Polymer 80 PF940SC Glock 26 frame in mind.</p> <p>Note:</p> <p>In my experience, it was a tight fit and a bit tricky adding the last 2 - 3 (13 rounds total) rounds to the Factory 10rd magazine, I had to use a Glock Magazine Loader to push down on the magazine/rounds, and load the remaining rounds. Inserting the last 2 - 3 cartridges, I also had to slightly remove the mag extension, a tad bit (like half an inch, more or less) so there would be more clearance with the spring inside of the magazine to push down the rest of the cartridges.</p> <p>Enjoy!</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Monoprice</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Maker Ultimate</p></div> <p><strong>Rafts:</strong></p> <p>Doesn't Matter</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>100%</p></div> <p><strong>Filament:</strong> PRILINE Carbon Fiber Polycarbonate Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>You may need a little bit of post-processing/sanding. You also may need to adjust print settings and or the print file dimensions slightly, especially if using different filament material.</p> Also, <p>For added strength and stability you can print the orientation of the model with the front, flat portion to the bottom of the build plate, and the back-lip portion to the top, with this orientation you will need supports.</p> </div></p></p></p> Category: DIY