Glider Ornament

prusaprinters

<p>The glider prints in two halfs, that way you dont need supports.&nbsp;</p><p>For print settings I used the standard 0.1mm profile and increased support to 25%. That way the balance front to back is pretty spot on. You will probably also want to turn down/off the Elefantfoot compensation, so there is no gap down the middle.</p><p>For assambly there are two holes in each part, where you can stick in a pieces of filament (about 5mm long) for alignment.</p><p>The original glider is a Twin Astir Trainer and I used a scale of 1:100</p>