Glider fpv pod for Eclipson Glider by Pauldrones

cults3d

To assemble the Pod we will follow the steps below: We will drill a 6mm hole in the center of the fuselage about 3cm from the cockpit lock (photo 0) and use as a guide the TPU inner mast with the 6 x70mm tube inserted and thus make the two 1.5mm holes that are to fix the unit (F 10). To the base (in principle the one with the camera at 16mm from the front end F1) we screw the external mast (F2) and pass the cables, if they are already soldered to the Air Unit we will have to remove the pins to pass them through the 6x70mm tube of the mast (F3_4_6). Now we check that the Pod is aligned before gluing the mast base (STL flat mast base) inside the fuselage over the wing socket, once centered proceed to glue (F5) The 6 x 70mm tube if it has play inside the TPU mast we can glue it to the mast (F6). Now we simply mount our Air Unit to the base (F7_8_9). We mount the Pod on the TPU Mast and proceed to fix it with a M2x12 screw (F11). The dome carries the talaros which we use as a guide to drill the wall of the base, so it will fit perfectly.