Glass Shelf Support Holders for Models/Minifigs Display

thingiverse

I designed these to hold a 3mm thick by 200mm wide glass or plexiglass shelf at a specific height of 130mm, to fit my giant Lego minifigs and other models perfectly. I also added small front and rear lips to prevent the glass from sliding forward or backward accidentally. The end holders are 15mm wide, while the middle holder is 10mm wide. The glass or plexiglass shelf will stand at a height of 130mm. Each support was made in two pieces due to the size limitation of my original printer bed at the time. Simply print the 15mm Part 1 and Part 2 - one for each end support you need, usually two supports, one at each end. Then print the 10mm Part 1 and Part 2 - approximately one full middle support for every 1000mm (40") of shelf, or about every 500mm (20"). Printed in PLA, they snap together tightly - if using a glass shelf longer than 1000mm (40"), it's suggested that you glue the two pieces (Part 1 and Part 2) together. Theoretically, you can use as many 10mm assembled middle supports as needed for your length of glass or plexiglass shelf. The Sketchup files are included, if you wish to change the dimensions for your specific needs.